Author Topic: Running the program  (Read 2265 times)

0 Members and 1 Guest are viewing this topic.

CommanderNazri

Running the program
« on: September 26, 2011, 01:54:27 PM »
I would like to know is that necessary to Run this program attach with protoboard (hardware).
I just want to make sure that I run this program correctly. ;)

Jaime Patarroyo

Re: Running the program
« Reply #1 on: September 26, 2011, 11:44:34 PM »
You don't have to have the board connected when you run the software. You can even write the code and verify it without the board. You just have to plug it when you want to upload the code, but even if you try to upload it without the board attached the program won't mess up.

CommanderNazri

Re: Running the program
« Reply #2 on: September 29, 2011, 06:22:12 PM »
Yes, thank you very much. Is that possible to design the circuit simulator to check with the program? :)

Jaime Patarroyo

Re: Running the program
« Reply #3 on: October 02, 2011, 06:00:51 PM »
I once asked for that also, but as I understand, thats something very hard to achieve. I don't know the exact reason but I think it has something to do with the time it takes to each computer to complete a task depending on the processor.

barragan

Re: Running the program
« Reply #4 on: October 02, 2011, 06:08:39 PM »
yeas, you probably will need to use some special hardware for it, change fuses to enable the JTAG pins used for that sort of things.

reem mohamed amr

Re: Running the program
« Reply #5 on: December 17, 2011, 01:15:30 AM »
i want to know the header including the order "constrain" plz