imagelogin

Author Topic: Arduino Library Errors - using Autodriver library from Sparkfun  (Read 2625 times)

0 Members and 1 Guest are viewing this topic.

kksbolash

Arduino Library Errors - using Autodriver library from Sparkfun
« on: December 03, 2014, 03:54:55 PM »
I had heard a rumor that Arduino libs might be used on the wiring board.
SO that being said. I have dropped the Sparkfun library for the Autodriver in to the Wiring libraries directory ...
When I compile the project code the following error occurs:

Error: 'byte' has not been declared ...
Similarly a few lines down in the error trail I see:
Error: 'boolean' has not been declared ...

So I am detecting a trend  :)

Does anyone have some suggestions porting an Arduino library to Wiring.
I heard rumors of an Arduino.h file that I might be missing etc.
I can share the sketch code if necessary. But it seems I am up against some more fundamental issues than that at the moment ...

Qynx

Re: Arduino Library Errors - using Autodriver library from Sparkfun
« Reply #1 on: December 08, 2014, 05:41:18 PM »
Please share the library, i'm very busy but I can try.

Regards,


Rob

kksbolash

Re: Arduino Library Errors - using Autodriver library from Sparkfun
« Reply #2 on: December 09, 2014, 03:23:42 PM »
Here is the Autodriver library, to be placed in the libraries directory as I am sure you may know. :-)

Also included is the sketch code ...

Any advice you can share would be wonderful.

Qynx

Re: Arduino Library Errors - using Autodriver library from Sparkfun
« Reply #3 on: December 10, 2014, 05:08:08 PM »
uh.. maybe it's my browser, but I don't see included files???  :-[

kksbolash

Re: Arduino Library Errors - using Autodriver library from Sparkfun
« Reply #4 on: December 26, 2014, 09:59:19 PM »
You should see the files.
Are you still not able to see them?

Qynx

Re: Arduino Library Errors - using Autodriver library from Sparkfun
« Reply #5 on: December 27, 2014, 06:24:00 PM »
Yes, it was browser related.....
After this weekend I start with it.