Wiring Forum

All Forums => Contributed Library Questions => Topic started by: kksbolash on December 03, 2014, 03:54:55 PM

Title: Arduino Library Errors - using Autodriver library from Sparkfun
Post by: kksbolash on December 03, 2014, 03:54:55 PM
I had heard a rumor that Arduino libs might be used on the wiring board.
SO that being said. I have dropped the Sparkfun library for the Autodriver in to the Wiring libraries directory ...
When I compile the project code the following error occurs:

Error: 'byte' has not been declared ...
Similarly a few lines down in the error trail I see:
Error: 'boolean' has not been declared ...

So I am detecting a trend  :)

Does anyone have some suggestions porting an Arduino library to Wiring.
I heard rumors of an Arduino.h file that I might be missing etc.
I can share the sketch code if necessary. But it seems I am up against some more fundamental issues than that at the moment ...
Title: Re: Arduino Library Errors - using Autodriver library from Sparkfun
Post by: Qynx on December 08, 2014, 05:41:18 PM
Please share the library, i'm very busy but I can try.

Regards,


Rob
Title: Re: Arduino Library Errors - using Autodriver library from Sparkfun
Post by: kksbolash on December 09, 2014, 03:23:42 PM
Here is the Autodriver library, to be placed in the libraries directory as I am sure you may know. :-)

Also included is the sketch code ...

Any advice you can share would be wonderful.
Title: Re: Arduino Library Errors - using Autodriver library from Sparkfun
Post by: Qynx on December 10, 2014, 05:08:08 PM
uh.. maybe it's my browser, but I don't see included files???  :-[
Title: Re: Arduino Library Errors - using Autodriver library from Sparkfun
Post by: kksbolash on December 26, 2014, 09:59:19 PM
You should see the files.
Are you still not able to see them?
Title: Re: Arduino Library Errors - using Autodriver library from Sparkfun
Post by: Qynx on December 27, 2014, 06:24:00 PM
Yes, it was browser related.....
After this weekend I start with it.