Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - MCU6811

Pages: [1]
1
Wiring Hardware Questions / Re: ATmega 128 bootloader + fuses
« on: July 15, 2011, 06:27:09 PM »
I tried the procedure you suggested but I keep getting the error:

avrdude was compiled without usb support.

I'm running everything on a windows XP machine.
2
Wiring Hardware Questions / Re: ATmega 128 bootloader + fuses
« on: July 15, 2011, 02:32:57 AM »
If I used wiring, would I just need the cpp file?

http://wiring.uniandes.edu.co/source/trunk/wiring/firmware/hardware/Wiring/Wiring1Sparkfun/BoardDefs.cpp?revision=1160&view=markup

I tried the above link but it wouldn't even verify.
3
Wiring Hardware Questions / ATmega 128 bootloader + fuses
« on: July 14, 2011, 08:11:32 PM »
I'm trying to upload a bootloader onto a new ATmega128 16MHZ chip attached to the wiring programmer using the AVR ISP mkII programmer through AVR studios 4.
Unfortunately, I was unable to make the LED flash with the following settings:

AVR bootloaders: http://www.procyonengineering.com/embedded/avr/bootloader/index.html

ATmega fuses: http://www.ethernut.de/en/isp/fuses.html

with the best result as a partial flash with the STK500 Protocol v2 STK500/UART 0 1Kword 16.000MHz hex file. If someone could direct me to the correct bootloader with the fuse setting that would be great.
Pages: [1]