Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - busred

Pages: [1]
1
General Discussion / quick question for the experts
« on: June 26, 2013, 04:59:22 PM »
Hi, I'm sure this is a doddle to you lot but I am having no end of trouble. The problem is that the wiring module I have left in a cupboard for 5 years and recently got out dose'nt want to be downloaded to. It has the ATMEGA128 chip on it and in pencil V1 over that, so I guess firmware V1. The only other ID i can see on it is A-02 C0407 on the PCB.

   I downloaded WIRING build 100, ran the FDTI and connected the board to my MACbookpro on OSx10.7.5. When I compile and download a program pressing the reset on the Board sets it to wait for the program and I see a flash on the RX TX corresponding with the line on the wiring program;

avrdude: stk500v2_ReceiveMessage(): timeout

the board does not go back to its program, which is flashing pin 48.

From what I have found on forums so far I think my serial comms is good but maybe the bootloader on the board has become corrupted? Whats the opinion of the web people and is there anything I can do?

Simon.
Pages: [1]