login

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - MCU6811

Pages: [1]
1
Wiring Hardware Questions / Re: ATmega 128 bootloader + fuses
« on: July 15, 2011, 06:27:09 PM »
I tried the procedure you suggested but I keep getting the error:

avrdude was compiled without usb support.

I'm running everything on a windows XP machine.
2
Wiring Hardware Questions / Re: ATmega 128 bootloader + fuses
« on: July 15, 2011, 02:32:57 AM »
If I used wiring, would I just need the cpp file?

http://wiring.uniandes.edu.co/source/trunk/wiring/firmware/hardware/Wiring/Wiring1Sparkfun/BoardDefs.cpp?revision=1160&view=markup

I tried the above link but it wouldn't even verify.
3
Wiring Hardware Questions / ATmega 128 bootloader + fuses
« on: July 14, 2011, 08:11:32 PM »
I'm trying to upload a bootloader onto a new ATmega128 16MHZ chip attached to the wiring programmer using the AVR ISP mkII programmer through AVR studios 4.
Unfortunately, I was unable to make the LED flash with the following settings:

AVR bootloaders: http://www.procyonengineering.com/embedded/avr/bootloader/index.html

ATmega fuses: http://www.ethernut.de/en/isp/fuses.html

with the best result as a partial flash with the STK500 Protocol v2 STK500/UART 0 1Kword 16.000MHz hex file. If someone could direct me to the correct bootloader with the fuse setting that would be great.
Pages: [1]